Read blueprints, maintain clean work environment, Assemble concrete communications building in accordance with VFP, Inc. standards. Ability to perform job duties with little to no supervision.
•Hook four ways and extension to crane and then to floor. Set floor onto dollies in bay.
•Spread grout around floor, paint grout with tams coat, seal floor, put weather strip and lay plastic around floor.
•Hook crane to beam, set long walls, chip plates, put butle tape on walls, set end walls, tighten jacks to get all gaps ¼” apart. Set roof onto walls.
•Chip and clean concrete residue from all roof plates, clean with wire brush, weld all plates, take all jacks off buildings
•Request Quality Control Technician to inspect building.
•Sweep inside of building, remove jacks and push building down track to Patch/Paint Department.
•Responsible for daily clean up at the end of shift.
•Direct point of contact for Concrete Supervisor in providing daily tasks for assembly/welding area.
•Must have current welder certification. Oversees and provides guidance in welding with other employees.
•Trains new employees in VFP standards and procedures and cross-train existing employees, when necessary, in other job duties.
•Performs other duties as assigned by the Supervisor/Manager.
Qualifications
Education
High school diploma or general education diploma (GED).
Preferred Experience
1-3 years welding experience
Certificates, Licenses or Registrations
Welding certification not required, but preferred
Knowledge/Skills
•Ability to follow written and oral instructions.
•Ability to read blueprints and tape measure.
•Must have knowledge and skills in the use of electric welding equipment.
•Must have knowledge and skills in operation of crane.
Basic knowledge of math (addition, subtraction, multiplication and division).